How To Drain A Waterbed With A Hose Youtube

June 18, 2021

If it still seems a big confusing or we did not explain what to do in a way that is clear, please give us a. Tools needed are a drain & fill kit, or an electric pump.

Pin on Survival

Allows you to properly fill your water compartment or compartments.

How to drain a waterbed with a hose youtube. Turn your faucet until it starts to send water out through both hoses. Watch to see when the first hose is full. Screw the faucet adapter to the faucet (a) and connect the super pump to the adapter.

Thanks guys for the help on draining the waterbed, but i can't fit the hose into the bed so i think i use the drain kit adapter but i don't know how it installs. If you do not have a floor drain, let the water drain out of the drain hose and into. Once the waterbed was filled, the plastic piece broke when removing from the kitchen faucet!!

Demonstrated in the youtube “afloat waterbed assembly” video. Before using the hose flush it through with clean water for about ten minutes. Start by removing all bedding from the waterbed.

I willing to siphon but i can't get the hose connected to the bed. Let the end of the hose stretch out on the ground in an area that can take the run off. Release the kink in the hose and set the hose end down once you reach the designated drainage area.

Attach perfect union® to the remaining end of the. Attach a hose to the waterbed mattress to drain it. About every 30 seconds, i could feed the hose several more feet until it was clear enough that the hose actually made its way out of the drain and up into the downspout.

The plastic piece you are given for hook up from the kitchen faucet to your garden hose, is a piece of junk!! Attach one end of a garden hose to a faucet outside the house and the other end to the waterbed's drain valve. The hose can be lower than the bed.

Pumps can be rented or purchased through your dealer. Carry the kinked end of the hose to the drainage location, holding the hose end higher than the level of the water in the pool as you walk. Epoxy and jb weld require the mixing of two separate chemicals that bond extremely tightly when they harden.

Allows you to turn the water off and on without running back to the faucet or other water source. You might need a second person to be waiting outside by the spigot. Enjoy the videos and music you love, upload original content, and share it all with friends, family, and the world on youtube.

You can buy a waterbed pump that hooks up to a drill at the hardware store, this will let you pump the water outside or up to the toilet. Your washer may contain from 5 to 10 gallons of water. Turn on the water for 15 seconds.

Attach hose to the super pump (e). This will leave you with one hose that is full of water and connected to both. If mattress has been in storage and conditioners were not added, add two 8 oz bottles of blue magic® waterbed conditioner.

Quickly turn the water off and then unscrew the hose from the outside faucet. If so you may have to use one of them, like a toilet that you know has a working drain. The hose went in about 3' before hitting a clog.

To use the siphon effect you need to have a hose that will reach from the waterbed to the outside of the house. Threads on to the male end of the hose. After stripping your bed, take a few towels and place them around the waterbed.

As waterbed mania swept the nation, specialty outlets like waterbed plaza, waterbed emporium, and the waterbed store opened up shop, and wave after wave of cheesy local television ads followed. For a king hard side and 30 minutes with a king soft. Drain the hose and carry one end up to the water bed.

See more ideas about water bed, water bed mattress, water mattress. Epoxy, jb weld and silicone bathroom caulk have been used as adhesive for homemade waterbed patches. Set the hose on the floor through the house and out.

This includes removing mattress pads, sheets, comforters, pillows, and everything else. Turn the water on for about 15 seconds to get the water flowing into the waterbed. Allow the hose to run until a steady stream of water spills out into the bucket next to the bed.

Below we have included some drain and fill instructions we hope you will find helpful and make your job easier and faster. How to drain your waterbed with super pump. To get the water out from the very bottom of your washer, disconnect the drain hose from the wall.

) the rest of the bed set up was simple!! The process takes up to 50 minutes approx. To drain the bed you are going to cause a reverse siphon.

The innomax® thermal guardian® hardside heater installation video goes through assembly & safe setup of your touch temp™ and/or quantum™ waterbed heater. Fill meter & fill chart: Attach one end of a garden hose to a faucet outside the house and the other end to the waterbed's drain valve.

Attach the garden hose to the outside spigot and turn on the hose. Position the drain hose as low as possible and into a floor drain if possible to empty the water. The plastic piece leaked the whole time while filling up the bed!!

How to drain a waterbed with a hose and whitout a pump softside waterbed mattress. I turned the water on high, and what came out look like motor oil! 3) time to fill the bed with water!!

Next the draining process is best done with the proper tools. The hose can be lower than the bed. You can also use a shop vac the other option is to find the drain under the water and run a snake through it.

Then, turn the shut off valve into the off position. This video is intended for hardside waterbed installation only. Drain and dry the bed out, since most adhesives stick better to a surface that's not wet.

Running water through the hose will eliminate any remaining air from the hose. The drain & fill kit | conditioner is the complete h2o package and it has everything you need to fill and drain either a hardside waterbeds or a softside waterbed. Ultimately, you won’t be able to drain the bed without stripping it.place towels at the foot of your bed.

This will create a continuous siphon by pushing the air that is in the garden hose into the mattress. This will aid in the draining process. You can then disconnect the second hose from both the faucet and the valve.

Turn on the water for 15 seconds. Electric waterbed pumps are the fastest method.

Pin on The Fixer Upper